Home -> Details
UPS 4KW

       UPS users manual

 

(Please read the manual carefully before using)

   Qinhuangdao Xinchi Photoelectricity Technology Co., Ltd

 

 

Operation Panel

 

Uninterruptible Power Supply

ModelXC-BD-UPS0001

Input:  AC100V-50Hz/60Hz-1.5Kw   

Output: AC100V-50Hz-3Kw

Battery Nominal Voltage51.8V

Battery Capacity: 4KWh

Protection Grade: IP32

2. Technique specification

Item

Technology standard

AC power supply input port

1 units

AC input voltage

AC110V 15V

Max. Input current

AC15A

 

AC power supply output port

2 units

Inverter output voltage

AC110V 5V

Inverter output power

3KVA

AC output switch

1 unit

Limited current of AC output switch

AC10A

 

Inner battery cell model

XC-CSM1865130

Battery pack solution

8P14S

Battery pack Nominal Voltage

DC51.2V

Battery pack working voltage range

DC32V-58.4V

Battery pack max. storage energy

4.1KW.H

Battery pack charge current

15A

Max. Charge voltage

DC58.4V

Battery pack main control air switch

1units

Limited current of Battery pack main control air switch

15A

 

Solar input port

1 unit(SB50)

Remark: when battery pack is full, automatically cut off the solar input port

Solar Charge current

10A

Solar cell power

800W

 

Affix 2: Inversion System Parameters 

 

Item

Technical Index

Nominal Output Capacity

3KVA

Overvoltage Protection for Inverter Input

68V DC

Overvoltage Recover for Inverter Input

66V DC

Floating Current

0.42A

Output Waveform

Pure Sine Wave

Display Mode

LCD Screen

Nominal Output Voltage

110V AC

Waveform Distortion Rate

4%

Output Frequency

60Hz0.5Hz

Dynamic Response

5%

Overload Ability

120%(1 minute), 150%(10 seconds)

Inversion Efficiency

Max 90%

Protective Function

Inverter output overvoltage protection, Output overload protection, Output short-circuit protection, overheat protection

Working Temperature

-20~50C

Working Altitude

4000m

Working Humidity

0~90%, no moisture condensation

 

Affix 3: Charging System Parameters

 

Item

Technical Index

Input Voltage Range

AC110V

Output Voltage

58.8V

Output current

15A

Overload Adjustment Rate

Output5%~100% Full load

Efficiency

Output Full Load

Dynamic Response

20%~100% overload

Input protection (Output 50% overload)

Overvoltage protection, stop output

 

Normal power grid, recover output

Output overvoltage protection

Overvoltage protection, stop output

 

 

Working state


When open the invert switchthe equipment outputs 100Vthe socket and terminals N L back of the equipment could output 100V.

The display screen of inverter  will show two voltage values. The first one is battery voltage, the second one is output voltage(100V normally)

Battery capacity indicator


Battery capacity indicator will light. Please charge in time when the last one indicator light. It completely is not necessary that do the charge until the batteries discharge to zero.

Charging state


Make the 100V alternating current access the connection ports AC IN back of battery, then open the charge switch. At this time, the charge display screen will display. And the switch near screen will change over the current display and the voltage display.

The current is 0A, voltage is 58~58.8V, which means that the charging has reach fullat this time all the indicators will light, in the situation of invert open
Based on characters of this battery, the charging at any time will not  injure battery. So, please do charge in time if you can.

 

 

It will take 5 hours from full discharging to full charging.

 

The time of charging is depends on the using of the home equipment.. 2kwh equipment as Example,it can supply 2hours.

 

Using Guide

u      Environment condition

2           Charge temperature 045

2           Discharge temperature -2055

2           Storage temperature -2035

2           Altitude no more than 2000m

2           Average relative humidity no more than 65%25棩

2           Away from application in seriously tremble

2           No corrosive gas in the surrounding medium

 

 

Transportation and storage

u          Transportation

In transportation, the battery should be gently moved in the delivery period, throw, roll and pressure are forbidden to the battery.

u         Storage

In the process of storage, the loaded retention should be less than 50% and have a charge every six months. Optimum storage temperature is 530 in dry, clean and ventilation room.

Storage battery should avoid direct sunshine and placed more than 2m away from heat source.

Battery shouldnt be inversed, and avoid mechanical impact or stress.

Attention items

u      Far away from heat, water and fire.

u      Dont disassemble, reassemble, dissection battery or battery group.

u      No disassemble and refit of the charger.

u      Dont reverse the battery positive electrode and negative electrode.

u      Dont short circuit the battery positive electrode and negative electrode.

u      Dont put the charger and battery in water or wet place.

u      Dont cast charger and battery randomly.

u      Dont puncture, scar the battery.

u      Dont use the battery in other fields.

u      Using special charger to charge.

u      Carefully read the specification before using the battery.

u      Every three months the battery should be charged two hours.

 

NO WARRANTY IF USED FOR UTMOST TESTING